SolaDeck 0999-5B
Currently out of stock. Contact us for lead time.
About this item
Full details for this product are in the Specs tab and on the manufacturer documents linked above.
More Racking & Mounting
End Clamp
The UFO-END is the end clamp for the IronRidge XR rail system. It sits at the outside edge of each row where the last module needs to be locked down without a second module pressing against it. Two per row, one at each end. Drop the clamp into the XR rail T-slot, set the end module against it, torque to spec. It bonds the module frame to the rail electrically as part of the IronRidge Integrated Grounding System, so you don't need a separate grounding lug at the row ends. Pair with UFO mid clamps along the rest of the row. The two together cover every module-to-rail attachment in a standard residential install. UL 2703 listed. 25-year IronRidge warranty.
$5.28
EZ Solar Rooftop PV J-Box (Asphalt Shingle)
The JB-1.2 is a flashed rooftop junction box for asphalt shingle roofs. Use it as the transition point between your rooftop module conductors and a conduit run heading to the inverter. The polycarbonate box mounts under the shingle with an integrated flashing skirt, so the roof penetration ends up under the next course of shingles and stays watertight. Rated 1000 VDC, 80 A, with a wire range of 14 AWG to 6 AWG. Type 3R enclosure, fits roof slopes from 2.5:12 to 12:12. One inch is the max conduit fitting size on both the side wall and the floor pass-through, which covers EMT, liquidtight, and most flex sizes you'd run on a residential array. Listed to UL1741 and CSA C22.2 No. 290. Operating range from -35°C to +75°C, which covers Gulf coast attic conditions year-round. Worth knowing: EZ Solar has discontinued the JB-1.2 and replaced it with the JB-F.100. The JB-1.2 still works fine on asphalt shingle and matches existing inventory, but for new designs going forward, the JB-F.100 is the newer part to spec.
$54.19
Grounding Lug
The XR-LUG is the low-profile grounding lug for XR rails. Drop it into the rail T-slot, run your equipment grounding conductor through it, torque. It connects the array's bonded rails to your EGC at a single point per row (or per the layout your inspector signs off on). Most installs run a single 10 AWG copper EGC through the XR-LUG and out to the inverter or combiner ground bus. The lug accepts solid or stranded copper. Even though the UFO mid clamps and BOSS splices already bond rails and modules into the IronRidge Integrated Grounding system, you still need at least one external lug per array to land the EGC. That's what this part does. UL 2703 listed as part of the XR system. 25-year IronRidge warranty.
$8.06